the length

All ski boots manufacturers, except Lange and Raichle, have started producing their boots in mondopoint sizes in the last few years. It is simply a technical term for the metric length of an internal trunk cavity expressed in centimeters.

To find your Mundopoint size, place a metric ruler on a hard surface with a “zero” end on the wall.

Place one heel on the wall and read the length of your foot at the tip of your big toe to the nearest millimeter mark. This is the size of your mundopint. (To determine the size of your respective United States, add the first two digits of your monopoint size. If your monopoint size ends at 5.5, add ½ to the result. The formula works up to 29.5. Size 30 equals 12 US Is.) Then measure. The other leg The length of the left and right legs often varies by half a size (a difference of more than half a size may be the result of a difference in the length of the leg, which may require medical attention). If your foot length is really different, always try to fit the smaller foot and ask the boot technician to adjust the other boot for the longer foot. Which ensures maximum control.

Remember, the size of your footpoint is just the beginning of your search. Because of the other last features (“last” refers to the lining) and the type of cover used, you should always try on boots that are smaller than the measured size of your foot and never buy boots larger than your street shoes.

A good measure of the weather in which boots are in your size range is to put your foot in the shell while the inside of the boot is removed. Slide your foot forward until your longest finger just touches the front of the boots. If you are 2 to 1 inch behind your heel (for top professionals, 2-8.3 inches), you are on the ball.

WIDTH

To find your width, stand with a metric ruler in the center below your ball. Read the width to the nearest millimeter and check the diagram below.

Read the first column of the chart to the length of your bipod and read across it to find the closest measurement to your metric width. Read to determine if your leg is narrow, medium or wide.

Toe shape

The arch of your toes determines how comfortable you are in the toe box of your ski boots. Most ski boots are designed to be made with round toes (see figure).

To achieve the best performance fit, skiers with angled toes should start with the right boots, and with a boot technology, pull the toe area of ​​the liner and / or shell. Skiers with square toes should look for boots with wider toes.

It is relatively common for the second finger to be longer than the first finger (this is called a Morton finger). In this case, your fitter should place you in a shell designed to accommodate the big toe and pull the liner and / or shell to make room for the second toe.

Tail height of the foot

The height of the sole of the foot is perhaps the most important part of a ski boot. For example, skiers who have too much volume in the foot area tend to fasten the second buckle tightly to secure the foot. This can compress the arteries and nerves above the foot and cause numbness, coldness of the toes or pain under the ball.

The easiest way to tell if your stride is high, normal, or low is to compare your foot to the images below and make a visual assessment.

To determine the height of your arch, sprinkle a generous layer of baby powder on the floor. Stand still with your bare feet and rest on the ground in the powder. Then go back and check your prints with the images below. Take photos of both feet: it may be different. The large difference between the heights of the two arches can be the result of a difference in leg length or injury. This problem can usually be solved with custom pedestals and / or the right size elevator, but the device must be prescribed by an orthopedist, foot specialist or chiropractor.

Heel area

If you want to maximize performance on the hill, an area from the ankle to the back is a good area. The looseness at the back allows the heel to lift at the beginning of the spin and slide forward at the end of the turn. To determine the shape of the hind foot, stand and look straight down at the heel.

On most feet, the ankle joints and the heel base are about the same width. For example, a wide ankle is usually associated with a wide heel, and the Achilles tendon will be almost invisible to the naked eye. A wide heel hides the ankle joints, which look wide and round. If you try to put one foot with a wide heel in a boot with a narrow heel pocket, it will not sit properly and this will allow the heel to be lifted.

A small heel has a thin Achilles tendon that usually protrudes from the foot and forms a deep sculpt between it and the ankle as it descends to the heel base. The ankle is significantly protruding from the foot.

Calf size

Most boots have buckle settings to accommodate a variety of calf shapes, but skiers with extraordinarily large or slender legs may need custom settings. Enough that does not twist the leg tightly, creates a delay time between the leg and the skiing movements. Enough that the calf does not fit the meat can be a tool of torture that prevents the foot from sitting flat on the boot and makes it impossible to close the boot. A good boot technician can customize your boots with cuffs or, in extreme cases, buckles.

To test the size of the calf, check the chart above and the height specified for your Mundopint size. Using your thumbs and index fingers, wrap around your legs with both hands.

If your toes are just touching, your calf is in the normal range. If your toes are on top of each other, your legs are narrow. If they overlap enough to meet at the first joint of your index finger, your calf is very narrow. If your toes can’t touch, your legs are wide.



Source by Jeffrey Rich